Seller assumes all responsibility for this listing..
Listing: #786072
Condition: New
Brand: WESTPRIME SYSTEMS
Type: Oxygen Sensor
Model: OOM110
MPN: OOM110
THIS PRODUCT IS NO LONGER AVAILABLE.
Oxygen Sensor OOM110
Made in Germany - ORIGINAL IN SEALED PACKAGING
For use with Datex Ohmeda: Aespire, Aestiva 3000, Airsys, Avance, Engstrom Modulus SE7900, Excel 210-7900, Modulus SE1700, S-5, Smart Vent.
Connector: Modular Jack 6P4C
Measurement Range: 0-100 % oxygen
Output in ambient air: 10 to 12mV
Electrical Interface: Modular Jack 6P4C
Accuracy and Repeatability: < 1 % vol. O2 when calibrated at 100 % Oxygen
Linearity error: < 3 % relative
Response time: < 12sec. to 90 % of final value
Zero Offset Voltage: < 200 µV in 100 % nitrogen applied after 5 min
Cross Interference: Meets EN ISO 21647 requirements
Influence of Humidity: - 0.03 % rel. per % RH at 25°C
Influence of Pressure: proportional to change in oxygen partial pressure
Influence of Mechanical Shock: < 1% relative after a fall from 1m
Operating Temperature: 0 to 50°C
Temperature Compensation: built-in NTC compensation
Effect of Temperature Compensation (steady state): relative error between 0 °C and +50 °C: 8 % relative error
Operating Humidity: 0-99% RH non-condensing
Long Term Output Drift: Storage Temperature: < 1 % vol oxygen per month typically < - 15 % relative over lifetime
Recommended Storage: +5 to +15 °C
Recommended Load: ≥ 10 kOhms
Warm-Up Time: < 30 minutes, after replacement of sensor
Nominal Sensor Lifetime: ≥ 1.000.000 % vol oxygen hours
Weight: approximately 50 grams
Part No. 01-00-0098
All specifications are applicable at standard conditions: 1013 hPa, 25°C dry ambient air
Advantages of Original German Made:
Meets EN ISO 21647
Designed and manufactured according to EN ISO 9001 and EN ISO 13485
Accurate and reliable response
Resistant to N2O
Excellent signal stability
High product quality